好氧触媒在造纸法再造烟叶污水处理中的应用分析

本文围绕好氧触媒在造纸法再造烟叶污水处理中的应用展开分析。如对好氧触媒在再造烟叶污水处理中的应用必要性及好氧触媒作用原理予以介绍,并对好氧触媒在造纸法再造烟叶污水处理中应用展开试验。     

How do you build back better so no one is left behind? Lessons from Sint Maarten,Dutch Caribbean,following Hurricane Irma

The Sendai Framework for Disaster Risk Reduction 2015–2030 and the United Nations’ Sustainable Development Goals call for action to build back better in ways that leave no one behind. At the same time, ensuring a local voice is increasingly central to humanitarian engagement. These aims contrast with limited analysis of how local actors might be supported in these respects during response and recovery, and how far recommendations are specific or generalisable across richer and poorer national contexts. The paper begins by comparing lessons learnt by survivors and community organisations in Sint Maarten, Dutch Caribbean, following a high‐income state‐led response to Hurricane Irma in 2017 with the priorities of lower income, humanitarian‐led endeavours. The differences reveal the importance of economic resources as the basis for individual self‐reliance and a fragmented civil society with limited leadership ambitions in Sint Maarten. Strong cross‐cultural alignment nevertheless allows for a globally‐relevant and yet contextually‐sensitive framework for survivor‐led action and reconstruction.     

低碳高氮污水处理应用技术研究

针对碳氮比小于7的污水,其碳源不能满足硝化与反硝化的要求这一问题,通过改变SBR工艺的运行方式、调解工艺参数等技术手段,使其能够达标处理此类工业废水,并通过某淀粉厂的工程实例进行了验证:采用改良的SBR工艺可以对低碳高氮污水进行有效的处理。     

内排压脚与边坡稳定性的关系

为了研究边坡角及边坡形状与边坡稳定性的关系,采用有限元软件ANSYS模拟了不同边坡角对应的稳定系数,以及不同平盘宽度和压脚高度所形成的等储备强度边坡的稳定系数。模拟中假设材料符合相关联的理想弹塑性本构关系,强度准则符合Drucker-Prager准则,用计算收敛性作为边坡稳定性的准则,用强度折减法得出边坡的稳定系数。为了形成等储备强度边坡,由下到上分步骤进行压脚。先在平面边坡最下台阶压脚,这样提高了边坡稳定系数,在边坡进入临界状态时,最下两台阶的塑性状态相同,则压脚停止;再在最下两台阶同时压脚,在边坡进入临界状态时,最下3个台阶的塑性状态相同,则压脚停止;以此类推,在最下边n个台阶同时压脚,在边坡进入临界状态时,压到与第n+1个台阶的塑性状态相同为止。结果表明,边坡总是从坡脚开始形成塑性区,在重力加载过程中,塑性区以弧形条带向坡顶扩展,形成滑带。最有效的内排压脚是从最下台阶开始形成等储备强度边坡的压脚。     

Result-oriented approaches to the management of drinking water catchments in agricultural landscapes

Management of water quality in drinking water catchments is of ongoing, high importance as nitrate concentrations are often still very high. We analysed the Augsburg catchment in Germany, a unique example where a result-oriented approach has been implemented. We investigated the historical evolution of the water protection programme, the result-oriented payment contracts with farmers, and farmer satisfaction with the contracts, based on interviews with the water utility and farmers as well as an analysis of the literature. Today, the water protection programme has been successfully implemented, and a significant reduction of nitrate concentration was achieved due to the following factors: (1) investment of non-negligible amounts of money for high compensation and remuneration payments, (2) different contract options, (3) farmers’ participation in the negotiation process for result-oriented payment contracts, (4) involvement of “outside” people and institutions in negotiation processes, (5) anticipation of starting a programme when nitrate levels were still far below legislative thresholds, and (6) a political and legislative framework allowing direct decisions by a water supplier.     

水力割缝增透抽采煤层瓦斯原理及应用

煤层瓦斯抽采是避免煤矿瓦斯灾害发生的根本防治措施,水力割缝技术使煤体在割缝后应力松弛、卸压、破坏、破裂,以成倍或者十几倍地提高煤层的渗透性,继而对煤层瓦斯进行抽采,使瓦斯煤层变为低瓦斯或无瓦斯煤层,从根本上避免瓦斯灾害发生。从水力割缝技术切割煤层致煤层应力变化角度,将理论分析和数值模拟方法相结合,根据渗流力学平面径向流理论,分析给出水力割缝技术增透抽采瓦斯原理。以兖州东滩矿3号煤层为例,分析采用水力割缝技术前后煤层应力变化、渗透率变化规律。结果表明:大面积割缝后,应力重新分布,由均匀状态转变为非均匀状态分布,水平缝使煤层卸压,煤层应力普遍降低,在缝上部煤层局部形成拉应力区。割缝后渗透率是割缝前的4.34倍,渗透率大幅度增加,从而提高瓦斯抽采速度和最终抽采率。     

深水悬臂桥墩动力特性及地震响应分析

利用ADINA中的势流体单元对一已建成的深水高墩建模,桥梁上部结构对桥墩的影响以墩顶集中质量的形式体现,分别对不同水深条件下桥墩-水体系的动力特性和地震动响应进行了系统的求解;为了检验Morison方程在深水桥墩动力分析中的有效性,将基于忽略速度力项的Morison方程的计算结果与基于势流体的结果进行了比较.研究结果表...     

Integrating soil carbon cycling with that of nitrogen and phosphorus in the watershed model SWAT: Theory and model testing

In this paper we describe and test a sub-model that integrates the cycling of carbon (C), nitrogen (N) and phosphorus (P) in the Soil Water Assessment Tool (SWAT) watershed model. The core of the sub-model is a multi-layer, one-pool soil organic carbon (S_C) algorithm, in which the decomposition rate of S_C and input rate to S_C (through decomposition and humification of residues) depend on the current size of S_C. The organic N and P fluxes are coupled to that of C and depend on the available mineral N and P, and the C:N and N:P ratios of the decomposing pools. Tillage explicitly affects the soil organic matter turnover rate through tool-specific coefficients. Unlike most models, the turnover of soil organic matter does not follow first order kinetics. Each soil layer has a specific maximum capacity to accumulate C or C saturation (S_x) that depends on texture and controls the turnover rate. It is shown in an analytical solution that S_x is a parameter with major influence in the model C dynamics. Testing with a 65-yr data set from the dryland wheat growing region in Oregon shows that the model adequately simulates the S_C dynamics in the topsoil (top 0.3 m) for three different treatments. Three key model parameters, the optimal decomposition and humification rates and a factor controlling the effect of soil moisture and temperature on the decomposition rate, showed low uncertainty as determined by generalized likelihood uncertainty estimation. Nonetheless, the parameter set that provided accurate simulations in the topsoil tended to overestimate S_C in the subsoil, suggesting that a mechanism that expresses at depth might not be represented in the current sub-model structure. The explicit integration of C, N, and P fluxes allows for a more cohesive simulation of nutrient cycling in the SWAT model. The sub-model has to be tested in forestland and rangeland in addition to agricultural land, and in diverse soils with extreme properties such high or low pH, an organic horizon, or volcanic soils.     

桉树叶提取液还原石墨烯电极提高微生物燃料电池产电性能的研究

将桉树叶提取液绿色还原氧化石墨烯(G-rGO)电极和微生物还原氧化石墨烯(B-rGO)电极依次作为微生物燃料电池(MFC)阳极,采用红外光谱(FTIR)、X射线衍射(XRD)、扫描电镜(SEM)对所制备的电极进行表征,并采用循环伏安法(CV)、交流阻抗法(EIS)对比2种电极的电化学性能.结果发现,G-rGO阳极的内阻为243.87Ω,应用于MFC时最大功率密度和最大输出电压分别为18.77 W·m~(-3)和760 mV,对照组B-rGO电极的内阻为299.11Ω,将其应用于MFC时最大功率密度和最大输出电压分别为13.16 W·m~(-3)和635 mV,对照组未修饰阳极的内阻为375.21Ω,最大功率密度和最大输出电压分别为8.97 W·m~(-3)和480 mV.研究表明,G-rGO电极电阻更小,导电性能更优越.     

南宁市一次污染过程大气颗粒物理化特性及来源

利用颗粒物粒径谱仪和单颗粒气溶胶质谱仪等,对南宁市2016年12月5~11日大气污染过程进行实时监测,分析颗粒物粒径分布特征、化学组分及其污染来源.结果表明,观测期间南宁市20 nm~10μm颗粒物数浓度粒径主要集中在23~395 nm之间,主峰值出现在100 nm左右.期间有3次新粒子生成现象,下午14:00~18:00有30 nm左右新粒子开始生成,晚20:00~次日06:00碰并长大到40~110 nm左右,3次新粒子生成过程受机动车尾气一次排放的污染影响.对污染期间细颗粒物化学成分在线溯源分析发现,污染期间有大量的二次反应颗粒物生成,判定颗粒物来源主要有生物质燃烧源、扬尘源和燃煤源,其中,远距离传输对生物质燃烧源有贡献.